Part 1 - Remote Setup
32
Motion Detection
Select
Motion Detection
to configure motion detection
event settings. With motion detection event enabled,
motion detections within the designated area will be
assumed as events.
•
Sensitivity
: Select daytime and nighttime motion
detection sensitivity levels. Higher values will result in
more sensitive motion detection.
•
Minimum Blocks for Detection
: Select minimum
blocks for daytime and nighttime motion detection.
Motion must take place over the selected number
of blocks in order for it to be considered as a motion
detection event.
•
Motion Zone
: Click
Setup
and define the motion
zone using blocks.
-
(Draw)/ (Erase)
: Enable/disable motion
detection blocks.
-
(Cell)
: Select/unselect motion detection blocks
individually.
-
(Region)
: Select/unselect multiple motion
detection blocks.
-
(Fill)
: Select/unselect all motion detection blocks.
•
Motion Ignoring Interval
: With Motion Ignoring
Interval configured, no event log or notification is
generated for motions detected during a period of
time following a motion detection event.
•
Daytime
: Specify when daytime starts and ends. All
other times will be assumed as nighttime.
•
Event Action
: Select a motion detection event alert
action.
-
Alarm Out
: Select if you wish to generate an alarm
out.
-
Send Email
: Select if you wish to send an email.
Select the
Image Attachment
option to attach a
.jpg image of the event detected to the email.
-
Remote Callback
: Select this option to send a
message to a remote system and then select which
system to send the message to.
•
Not supported from the IDIS Web program.
•
The camera must be registered to the remote
system in order to use the
Remote Callback
feature.
-
Audio Alarm
: Select this option to generate an
audio alert and then choose an audio file.
DC-
B4501X model only
-
FTP Upload
: Select this option if you wish to
upload images to the FTP server.
-
Record
: Select this option to record video.
-
Move PTZ to
: Select a preset position to move the
pan/tilt driver to that position. Preset positions can
be set from the remote program.
Event Action
settings must be configured correctly
in order to perform event actions.
