Part 1 - Remote Setup
18
•
WDR Level:
Set the strength. The larger the value, the
brighter the dark parts of the image.
•
Exposure Control:
Adjust Shutter Speed and gain.
This option is available only when
Anti-Flicker
and
Slow Shutter
are both set to
Off
.
-
Auto:
The system will assess the lighting
conditions and adjust the shutter speed and gain
automatically.
-
Manual:
Use the slider to select the desired shutter
speed and gain. Select the most suitable minimum
and maximum shutter speeds and gains for the
lighting conditions in the area where the camera is
located.
With certain features, selecting
Auto
automatically
loads settings suitable for the camera's installation
environment.
Day & Night
Configure
Day & Night
settings.
•
B&W Mode
: Display the images in greyscale for
greater clarity in low-lighting conditions.
-
On/Off
: Enable/disable B&W Mode.
-
Auto
: Allow the system to enable/disable B&W
Mode automatically.
-
Schedule
: Set up a B&W Mode schedule. B&W
Mode is enabled on days and times designated as
Nighttime
and disabled at all other times. Select
On
or
Off
at the bottom of the schedule table and
then click or drag on the dates and times to select/
unselect as
Nighttime
. Select
On
or
Off
and then
click
Select All/Clear All
to select/unselect all dates
and times as Nighttime.
•
IR Cut Filter
: IR Cut Filter blocks out the infrared
spectrum. You can ensure clear images at all times by
blocking out the infrared spectrum in high-lighting
conditions and allowing the infrared spectrum to pass
through in low-lighting conditions.
-
Nighttime Mode
/
Daytime Mode
: Disables or
enables the IR cut filter.
-
Auto
: Allow the system to enable/disable IR Cut
Filter automatically.
-
Schedule
: Sets up the IR cut filter schedule. The
IR cut filter is disabled during the date and time
scheduled as
Nighttime
and enabled during the
rest. Set up or release Nighttime by selecting
On
or
Off
in the bottom and clicking or dragging the date
and time area in the table. Selecting On or Off and
clicking the
Select All/Clear All
button sets up or
releases Nighttime for all dates and time.
•
Switching Mode:
Change the switching mode of
daytime and nighttime. In normal mode, daytime/
nighttime is switched through the amount of light
received by the ambient light sensor. In advanced
mode, it is switched through the amount of light and
