Part 1 - Remote Setup
32
Event Action
settings must be configured correctly
in order to perform event actions.
System Event
Select
System Event
and configure system event
settings. With system event enabled, system status,
alarm in status, and disk status will be checked
periodically and corresponding alerts will be generated.
•
System Alive
: Select to check the system status and
then set up a schedule.
-
Send Email
: Select to send out an email when the
system comes on line.
-
Remote Callback
: Select this option to send a
message to a remote system when the system
comes on line and then select which system to send
the message to.
•
Alarm In Bad:
Select to check the alarm in status and
then set up a schedule.
-
Send Email
:
Select to send out an email if no
change is detected in the alarm in status.
-
Remote Callback:
Select this option to send a
message to a remote system when the SD memory
card is inserted/removed and then select which
system to send the message to.
•
Disk In/Out
: Select to check if the SD memory card
has been inserted/removed.
-
Send Email
: Select to send out an email when the
SD memory card is inserted/removed.
-
Remote Callback
: Select this option to send a
message to a remote system when the SD memory
card is inserted/removed and then select which
system to send the message to.
•
Disk Bad
: Select to notifiy you if an error occurs on
the SD memory card.
-
Send Email
: Select to send out an email if an error
occurs on the SD memory card.
