Part 1 – Introduction
9
●
Lens
Fixed lens is installed.
●
Wall/Ceiling Installation Hole
Used to screw the camera in place on a wall or a
ceiling.
●
Dome Cover Screw Hole
Secures the dome cover to the camera.
●
Factory Reset Button
Restores the camera's default factory settings. For
more information, refer to the Factory Reset.
●
Cable
- Ferrite Core: It is provided for EMI (electromagnetic
interference) suppression.
- Network Port: Connect a network cable with
an RJ-45 connector to this port. The camera is
supplied with power over Ethernet cable by using
a PoE switch. For more information on PoE switch
use, refer to the switch manufacturer's operation
manual. You can configure, manage, and upgrade
this camera and monitor its images from a remote
computer over the network. For more information
on network connection setup, refer to the IDIS
Discovery operation manual.
- Video Out (BNC): Connect the monitor. Use these
ports for previewing video and not monitoring
video.
Camera surveillance may be prohibited by laws that
vary by region. Check the laws in your area before
using this product for surveillance purposes.
The network connector is not designed to be
connected directly with cable or wire intended for
outdoor use
.
Factory Reset
Only use the factory reset button to restore the camera
to its factory default settings.
A factory reset will clear all camera settings configured
by the user.
1
Shut off the power supply, separate the dome cover
from the camera body and push the factory reset
buttons.
2
Hold the button down and reconnect the power.
3
After connecting the power, wait 5 seconds and
then take out hands from the button.
4
The device will go through the resetting process and
reboot. All camera settings will be restored to their
factory defaults after the reboot.
5
Connect the dome cover to the camera body.
It's also possible to do a factory reset by pressing and
releasing the reset button while the camera is turned
on or using the IDIS Discovery program from a remote
location. A factory reset will reboot the system. For more
information on resetting the camera remotely, refer to
the IDIS Discovery operation manual.