Part 2 - Configuration
72
lines as being the end of a transaction.
●
Line Delimiter
: Designate a string to mark the end of
a line. You can enter control strings by selecting
and then entering ^, followed by a letter. For example,
Carriage Return is ^M and Line Feed (new line) is ^J.
●
Ignore String
: Specify a string to ignore from
transaction records.
●
Case Sensitive
: Ignores case in strings designated
under
Transaction Start
,
Transaction End
,
Line
Delimiter
, and
Ignore String
.
Case Sensitive
does not apply to control strings.
●
Time Out
: Once
Time Out
has been enabled, the
system will assume the end of a transaction if no new
string is entered within the specified duration of time.
Select between 5 secs and 15 mins.
●
Title
: Designate a name for the text-in device.
●
Actions
: Specify which actions to take when text-in is
detected.
–
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
–
Alarm-Out
: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
–
Notify
: Configure to be notified of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
–
PTZ
: Moves the PTZ camera to a specific preset position
when an event occurs.
–
Event Monitoring:
Selects the cameras to monitor when
an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
Device Setup
Refer to the
for basic
information on using the Setup menus.
Alarm-Out
A list of events for setting up Alarm-Out.
Alarm-Out_Setup
●
Source
: Specify the device to use for Alarm-In event.
–
Channel
: Set the channel of the source you set.
–
Sub Channel
: Set the sub channel of the source
you set.
●
Title
: Designate a name for the alarm-out.
●
Reverse Relay
: Reverse the alarm-out type of the
device you set at the source.
