Part 2 - Configuration
36
•
Motion Ignoring Time
: The system does not produce
event log entries or issues remote notifications
regarding motion detected during the specified time
following the initial motion detection. Set a value
between 1 sec and 10 secs or choose Never.
Motion Ignoring Time does not affect motion
detection recording.
•
Actions
: Specify which actions to take when motion
is detected.
–
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
–
Notify
: Configure to be notified of events by Mail,
LAN1 through 5, Push, and/or Alert Window.
–
PTZ
: Moves the PTZ camera to a specific preset
position when an event occurs.
In order to use the Callback feature, the DVR must be
registered on the remote program.
•
Daytime Setup
: Specify when daytime starts and
ends. Adjust the time frame in 15-minute increments.
Times outside the specified range will be assumed as
nighttime by the system.
Tripzone
•
No.
: Select which cameras to apply Motion Detection
to.
•
Sensitivity
: Set daytime and nighttime sensitivity
settings between 1 (Low) and 5 (High).
•
Zone
: Define the motion detection block.
