FDX-32 User
’s Guide
38
8.3 Setting input [INPUT SETTING]
8.3.1 [INPUT EQUALIZER]
If you select
“AUTO”, signals are corrected automatically depending on the amount of signal attenuation.
Using menu
INPUT SETTING → INPUT EQUALIZER
For
Each input connector (IN1 to IN32)
Set value
AUTO: Automatic correction [Default]
OFF : Without correction
【
NOTE
】
● If you do not press the “SET” key, the setting is not changed.
● If you use a 5 m/16.4 ft. or longer cable, we recommend testing the configuration
beforehand since it is greatly affected by the quality of the output signals and the like.
● Set this menu before operating the FDX, since the image may be disturbed when the setting is switched.
● Channels that do not have a digital input slot board cannot be selected in this menu.
