MSD-72 Series User’s Guide
89
9.9.4 Deep Color
Menu Top
→
EDID
→
DEEP COLOR INPUT
Setting for Each input channel (Digital input only)
Setting value 24-BIT COLOR [Default], 30-BIT COLOR
You can set the color depth to be output from the source device.
This menu is valid only if you select “INTERNAL EDID” for “
” and you select a resolution other than
“UNUSED” for “
9.9.3 Input resolution for AV devices
”.
If you select “30-BIT COLOR”, compared to “24-BIT COLOR”, “30-BIT COLOR” is transmitted using a higher
clock frequency, which may cause noise if a cable with a bad quality or a long cable is connected. In such a
case, the noise may be removed by setting the color to ”24-BIT COLOR”.
The setting of this menu is not updated until the MENU/SET key is pressed. Make sure to press the
MENU/SET key to update the setting.
9.9.5 Audio format
Menu Top
→
EDID
→
AUDIO FORMAT
Setting for Each input channel, digital input only
[Table 9.14] Audio format
Audio format
ON / OFF
Maximum sampling frequency (kHz)
PCM
Cannot be set
32 / 44.1 / 48 / 88.2 / 96 / 176.4 / 192 (48)
Dolby Digital
Can be set (OFF)
ON: 32 / 44.1 / 48 (48)
AAC
Can be set (OFF)
ON: 32 / 44.1 / 48 / 88.2 / 96 (48)
Dolby
Can be set (OFF)
ON: 32 / 44.1 / 48 (48)
DTS
Can be set (OFF)
ON: 32 / 44.1 / 48 / 96 (48)
DTS-HD
Can be set (OFF)
ON: 44.1 / 48 / 88.2 / 96 / 176.4 / 192 (192)
Dolby TrueHD
Can be set (OFF)
ON: 44.1 / 48 / 88.2 / 96 / 176.4 / 192 (96)
Default values are shown in parentheses.
You can set the audio format and maximum sampling frequency to be output from a source device.
This menu will be valid only if you select “INTERNAL EDID” for “
” and you select a resolution other
than “UNUSED” for
9.9.3 Input resolution for AV devices
”.
The setting of this menu is not updated until the MENU/SET key is pressed. Make sure to press the
MENU/SET key to update the setting.
