NJR-T01SDI Command Guide
25
4.5.2.5 LAN settings
@GIP / @SIP
LAN setting
Command group
N/A (only for NJR-CTB command server)
Function
Getting
Setting
Format
@GIP, device, ch, reserved
@SIP, device, ch, reserved, mode, ip,
mask, gateway
Return value
@GIP, device, ch, reserved, mode, ip,
mask, gateway
@SIP, device, ch, reserved, mode, ip,
mask, gateway
Parameter
device: Model
“1” (fixed).
ch: Channel
1 to 512 = Channel 1 to Channel 512
reserved: Reservation
“1” (fixed).
mode: IP address setting mode
0 = DHCP [Default], 1 = static
After “DHCP” is set, parameters will be invalid.
ip: IP address
0 to 255 = 8 bits (decimal) x 4 pairs
[Default] Automatic
mask: Subnet mask
0 to 255 = 8 bits (decimal) x 4 pairs
[Default] Automatic
gateway: Default gateway
0 to 255 = 8 bits (decimal) x 4 pairs
[Default] Automatic
Example
@GIP,1,1,1
@GIP,1,1,1,1,192.168.3.2,255.255.255.
0,192.168.3.254
Getting the LAN setting of channel 1.
- IP address setting mode : Static
- IP address
: 192.168.3.2
- Subnet mask
: 255.255.255.0
- Default gateway
: 192.168.3.254
@SIP,1,1,1,1,192.168.3.2,255.255.255.
0,192.168.3.254
@SIP,1,1,1,1,192.168.3.2,255.255.255.
0,192.168.3.254
Setting the LAN setting of channel 1 as
follows:
- IP address setting mode : Static
- IP address
: 192.168.3.2
- Subnet mask
: 255.255.255.0
- Default gateway
: 192.168.3.254
Completed normally.
Remarks
This command can be input only via the NJR-CTB command server.
If the LAN setting is changed, the communication may be disabled. Change the
environmental settings based on the NJR-T01SDI settings.
