(C) IDM ENERGIESYSTEME GMBH
4. Programming
Technical manaul EIB/KNX
8
D I E
E N E R G I E F A M I L I E
Pr
ogr
ammi
e
rung
4. Programming
4.1. Programming the EIB/KNX
Before starting to use the EIB-KNX module for the
fi rst time it must be programmed via the EIB/KNX bus.
The module is programmed via the ETS software
like all EIB/KNX devices. An ETS project with a pre-
confi gured module is available for programming the
EIB/KNX module
After importing the ETS project the module can be
copied into any ETS project.
4.2. EIB/KNX Objektbelegung
The detailed assignment of the objects can be infer-
red from the following table.
The confi guration of the objects and
the module‘s serial interface should
not be changed! If this is not observed,
fl awless operation cannot be guaran-
teed!
It is essential to ensure that the para-
meter values marked with an * in the
following table are not altered more
than is absolutely necessary. These
values are written directly into the
EEPROM memory of the Navigator. A
permanent alteration of these values
can result in damage to the memory.
The ETS project can be downloaded
from our website at
http://www.idm-
energie.at/
. (in the partner area under
accessories)
