Electronic Pushbutton Locks
EL730SLR
© 2017 IDN, Inc. All rights reserved.
0817
SETUP MODE
HOW TO DELETE AN INDIVIDUAL EXISTING REMOTE CONTROL
(only available for Remote Control Electronic Deadbolt)
Steps are as follows:
1. Press and hold [SET] button for over 2 seconds.
The Red LED will light up and beep twice. You are now under setup mode.
2. Enter 123456 (or current programming code) and then press button .
Enter [30] and press button .
Press any button on the remote control (that you wish to delete) and press button .
The Red LED will light up for 10 seconds.
The lockset will delete the existing remote control that you do not want.
(If a number of remote controls are to be deleted at the same time, press any button of the remote
control that you want to delete and press button on the keypad, and repeat above step prior to the
indicator light timing out 10 seconds after the last press of a keypad button.)
Note:
1.The lockset will go back to the standby status if no button is pressed in 10
seconds after accessing setup mode.
2.If any remote control is lost, for your safety, please delete all remote controls
and re-add current remote controls excluding the lost one.
33
A
A
A
A
A
A
A
A
SET
DEL
1
2
4
5
6
7
8
9
0
C
34
HOW TO DELETE ALL EXISTING USER CODES AT ONCE
SETUP MODE
Steps are as follows:
1. Press and hold [SET] button for over 2 seconds.
The Red LED will light up and beep twice. You are now under setup mode.
2. Enter 123456 (or current programming code) and then press button .
Enter [40] and press button .
Press and hold button until a beep is heard.
The Red LED will light up for 10 seconds.
The lockset will delete all existing user codes.
Note:
1.The lockset will go back to the standby status if no
button is pressed in 10 seconds after accessing setup mode.
C
