Electronic Pushbutton Locks
EL740S
© 2017 IDN, Inc. All rights reserved.
0817
HOW TO ADD A SINGLE-USE USER CODE / PROXIMITY CARD / REMOTE CONTROL
29
SETUP MODE
Steps are as follows:
1. Press and hold [SET] button for over 2 seconds. The Red LED will light up and beep twice.
You are now under setup mode.
2. Enter 123456 (or current programming code) and then press button .
3. We recommend to turn on auto-lock mode according to
page 38
before following the below steps to
enable single-use user code/ remote control.
single-use
Follow the below steps.
User code
Enter
[21]
Enter user
codes (4 digits)
Press any
button on the
remote control
Remote control
Proximity card
Press
button
Press button
User codes can be stored to
5 sets
Remote controls can be stored
to 5 sets
Touch the
inductive zone
Proximity cards can be stored
to 5 sets
30
Note:
1. The lockset will go back to the standby status if no button is pressed in 10 seconds after
accessing setup mode.
2. Single-use user code capacity: 5 sets maximum.
3. Single-use remote control capacity: 5 sets maximum.
4. Single-use proximity card capacity: 5 sets maximum.
5. Single-entry user code/ single-entry user remote control/ single-entry proximity card is only allowed to
work once and will become invalid after one-time use (entry).
6. Do not use your multiple-entry user code/ multiple-entry remote control/ multiple-entry proximity card
to facilitate single-entry operation, or your user code/ remote control/ proximity card will become invalid
after only one-time use (entry).
SETUP MODE
All manuals and user guides at all-guides.com
