Electronic Pushbutton Locks
EL740S
© 2017 IDN, Inc. All rights reserved.
0817
A
A
A
A
A
A
A
A
SET
DEL
1
2
3
4
5
6
7
8
9
0
C
31
HOW TO DELETE AN INDIVIDUAL EXISTING USER CODE
SETUP MODE
Steps are as follows:
1. Press and hold [SET] button for over 2 seconds. The Red LED will light up and beep twice.
You are now under setup mode.
2. Enter 123456 (or current programming code) and then press button .
Enter [30] and press button .
Enter existing user code (that you wish to delete) and press button .
The Red LED will light up for 10 seconds. The lockset will delete the existing user code that you
do not want.
(If a number of user codes are to be deleted at the same time, enter each user code to be deleted
and press on the keypad, and repeat above step prior to the indicator
light timing out 10 seconds after the last press of a
keypad button.)
Note:
1.The lockset will go back to the standby status if no button
is pressed in 10 seconds after accessing setup mode.
32
HOW TO DELETE AN INDIVIDUAL EXISTING PROXIMITY CARD
(only available for Proximity Card Electronic Deadbolt)
SETUP MODE
Steps are as follows:
1. Press and hold [SET] button for over 2 seconds. The Red LED will light up and beep twice.
You are now under setup mode.
2. Enter 123456 (or current programming code) and then press button .
Enter [30] and press button .
Put the card that you wish to delete to touch the inductive zone.
The Red LED will light up for 10 seconds. The lockset will delete the existing card that you do not want.
(If a number of cards are to be deleted at the same time, use every card to touch the inductive zone
consecutively prior to the indicator light timing out 10 seconds after the last press of a keypad button.)
Note:
1.The lockset will go back to the standby status if no button is pressed
in 10 seconds after accessing setup mode.
2.If any card is lost, for your safety, please delete all cards and re-add
current cards excluding the lost one.
All manuals and user guides at all-guides.com
