Supervisor password
BX2 Systems User’s Handbook
64
Chapter 2. Using the CMOS Setup Utility
3.
Select Supervisor Password from the Main Menu and press
Enter. The following message appears:
Warning: If you forget or lose the password,
the only way to access the system is to set
jumper JP5 to clear the CMOS RAM. All setup
information is lost and you must run the
BIOS setup program again.
If you do not want to use a password, press Enter.
4.
Enter your new password and press Enter.
5.
Re-enter your password and then press Enter to exit to the Main
Menu.
This diagram outlines the password selection procedure:
ROM PCI/ISA BIOS
CMOS SETUP UTILITY
AWARD SOFTWARE, INC.
STANDARD CMOS SETUP
BIOS FEATURES SETUP
CHIPSET FEATURES SETUP
POWER MANAGEMENT SETUP
PNP/PCI CONFIGURATION
LOAD SETUP DEFAULTS
LOAD BIOS DEFAULTS
INTEGRATED PERIPHERALS
SUPERVISOR PASSWORD
USER PASSWORD
IDE HDD AUTO DETECTION
SAVE & EXIT SETUP
EXIT WITHOUT SAVING
Esc
F10
: Quit
: Save & Exit Setup
↑
↓
→
←
(Shift) F2
: Select Item
: Change Color
Time, Date, Hard Disk Type…
Enter Password:
Enter Password:
*****
Password Disabled!!
Confirm Password:
*****
Press:
↔
Without entering password
Type the Password
Press:
↔
After you confirm the
password, press
°
to exit
Type the Password
and Press: <Enter>
Press <Enter> without
entering the password
After you confirm the password,
press <Esc> to exit
Summary of Contents for BX2
Page 1: ......
Page 66: ...BX2 Systems User s Handbook 66...
