SP410 User Manual
11
CHAPTER 3 MAINTENANCE & ADJUSTMENT
Adhesives and coatings of the media can transfer to the printer parts over time along the media
path including the thermal print head and media sensor. This build-up can accumulate dust and
debris. Failure to clean the print head, media path, and media sensor could result in inadvertent
loss of labels, label jams and possible damage to the printer.
Note:
1. Make sure to turn off the printer before cleaning.
2. As the print head gets hot during printing, if want to clean the print head, turn the printer off
and wait approximately 2~3 minute before commencement.
3. When cleaning the print head, do not to touch the heated portion of the print head.
Print Head is susceptible to damage from static electricity, etc. So, it is strongly recommended
to wear hand gloves during cleaning progress.
4. Do not to allow the print head become scratched and/or damaged in any way.
3.1 Cleaning Print Head
1. Open the printer cover and then use the cleaning pen to clean the head in the direction from
the center of the head to two sides.
2. After cleaning the head, do not use the printer until the alcohol used for cleaning evaporates
completely (1~2 min) and the printer has completely dried.
3.2 Cleaning Roller and Paper Path
1. Open the printer cover and then remove the paper.
2. Remove any dust or foreign substance using dry cloth or cotton swab.
3. Soak the cloth or cotton swab in alcohol for medical use and use it to remove adhesive
foreign substances or other pollution materials.
4. After cleaning the parts, do not use the printer until the alcohol evaporates completely (1~2
min) and the printer has completely dried
Summary of Contents for SP410
