IDS Imaging Development Systems GmbH
Mounting instructions
https://en.ids-imaging.com
Dimbacher Str. 10 · D-74182 Obersulm, Germany · T: +49 7134 96196-0 · E: info@ids-imaging.com
Corning C-S-25H0-096, 9,6 mm, 1/1.8"
10. At the camera, open the connector for the flex cable of the lens module by pulling off the black cap, see
figure below.
(Illustrations m ay differ from the original)
11. Plug the flex cable of the lens module into the connector so that the contacts show inward.
12. Fasten the connector by closing the black cap.
13. Connect the camera to the PC (camera is powered).
Using IDS peak
1. Open the camera in IDS peak Cockpit.
2. Open the settings for the camera parameters
via the "Focus" button in the camera window.
3. In the "Focus" dialog, you should be able to
adjust the focus of the lens module.
Using IDS Software Suite
1. Open the camera in uEye Cockpit.
2. Via the "uEye > Properties" menu, open the
settings for the camera parameters.
3. In the "Focus" tab, you should be able to adjust
the focus of the lens module.
Status: 2022-09-14
