©
2
0
2
0
In
te
llig
ent
D
ig
ita
l S
er
vic
es
G
mbH
V
e
rs
io
n
1
.0
11.2
Programming externally triggered routine
Depending on the type of signal that you want to use as trigger, you need to select
one of the tabs [RF], [IR], or [WIFI] first. All known input signals (that have been
successfully trained to the Gateway V1) will be shown assigned to a card.
•
Open one of the cards by clicking on the down-arrow.
•
Use the pulldown menu to connect the signal source to an action.
•
You may add up to 5 actions to this card by using the ”+” buttons, remove
them using the ”x” buttons.
•
If you want this routine to appear in the Scenes menu, select a location
from the “locations” pulldown selector.
•
Click the switch at the upper right of the card to enable/disable this
routine.
•
Click the [SAFE] button.
11.3
Configuring externally triggered routines
to scenes
RF or IR routines will become visible in the [SCENES] view as soon as a location is
selected, and the routine is switched to active state. Using the respective “location”