Important Warning :
-
Never open the equipment unless authorised to do so
by a member of the IDT Sound Processing
Corporation technical team and please follow the
instructions to the letter.
Location of the equipment:
-
The equipment must be located in an area that is dry and well ventilated.
-
The equipment should not be subjected to temperatures over 45°C and
should, where possible, be far from heat sources like transmitters or radiators.
-
The ventilation outlets of the Equipment must, in no case be obstructed.
-
Every precaution must be taken to make sure that no liquid should enter the
equipment. Should this happen unplug the equipment immediately.
Power Supply:
- The fuses in the power supply are standard, 2 AT 250 V. In case of use on a
115 Vac. network they should ideally be changed for 4AT 250V.
-
The equipment needs an AC power supply of 115 Vac or 230 Vac 50/60Hz and
must be properly earthed. There is an earth screw on the equipment for that
purpose. Should the equipment not be in use for a certain period it should be
unplugged.
-
The cables linked to the equipment must not be twisted, pinched, crushed or
changed in any way. All standards stipulated must be respected (maximum
length, shielded etc.). Please replace, immediately any cable that is damaged.
Never try auto-maintenance or repairs on any machine without the written
authorisation of IDT Sound Processing Corporation or a maintenance expert
mandated by the company (a list can be supplied by IDT Sound Processing
Corporation).
Should these conditions not be respected IDT Sound Processing Corporation shall
suspend all guarantees. Any damage which results can only be repaired by IDT
Sound Processing Corporation and any repairs will be invoiced.
2