Page 10
Getting to Start
ON, OFF, IDLE, RESTART
Connect
2DScan
and Host,
2DScan
will power on automatically and in "Idle" (ready to use) state (factory
default).
Power On
Power Off
There are 4 ways to "Power OFF":
Remove Cable Off
2DScan
;
»
Remove Power Adapter Off RS232 Cable;
»
Remove USB Cable
from
the Host;
»
Remove PS/2 cable
from
the Host. If a power adapter is connected, remove it too.
»
IDLE Mode
When reader is NOT reading, it is in "IDLE mode".
With n
o reading attempt within a timeout, the Imager
will
switch to IDLE mode automatically.
RESTART
If
2DScan
halted and does not respond to operations, please "Restart" by "Power OFF", and then "Power
ON".
Maintenance
The scan window must be kept clean. Improper maintenance will breach the limited warranty.
»
Avoid rough objects not to damage or scratch the window.
»
Use brush to remove the stain.
»
Use soft cloth (cloth for glasses) to clean.
»
Prohibit spraying towards the window.
»
Only use clean water as a cleanser.
»
