20030516
User’s Manual
50
STAR FINGER007
9.4.6 READER TEST
9.4.7 INPUT TEST
9.4.8 COMMUNICATION TEST
READER TEST
Scanning …
Reader 1
XXXXXXXX
Card No.
Reader No.
. To test the performance of the reader, press
<ENT>
key.
NOTE
: In case
FINGER007P
, you don’t using this menu.
The reader is waiting for an RF card to read. Present an RF card to the
reader. The test has completed successfully if the LCD displays the ID card
number(example shown to left)
INPUT TEST
. To test performance of input ports, press <ENT> key.
The lower line on the LCD indicates the status of the five input signals.
Note
:
1. Input 1~4
−
<1>
: No input signal,
<0>
: Exist input signal
2. Input 5
−
<0>
: No input signal,
<1>
: Exist input signal
INPUT TEST
1 1 1 1 1
COMM TEST
. To test performance of input ports, press
<ENT>
key.
(
Before this communication test, connect the RS-232 RX, TX wires
to each other.
)
If there is a problem with the communication performance, check
connections and try again.
As the test proceeds, you can see the characters being transmitted and
received. Finally LCD display communication test pass message.
COMM test pass !!
Press any key …
TX data = 0
COMM fail
