3.4 Open the attachment pack, take out the screws; With this
screw will play good expansion bolt installation device fixed
to the surface (wall or ceiling);
3.5 Plug the external cables according to the use requirements
of equipment.
Picture 4 Equipment installation diagram(2)
3.6 Using tools to adjust screw loose device;
3.7 The up and down or so regulating equipment, according to
the use requirements set equipment of direction;
3.8 Using tools to screw locking device;
4.Network Operation
4.1 Use correct power supply
4.2 After startup, connect the device with switch or router,
see below picture
Picture 5 Network structure
4.3 Make default IP address is 192.168.1.10
4.4 Go to CD->English->Software to find Upgrade Tool and
install it.
use the device ip address is in the same LAN of router, de
4.5 Run Upgrade Tool, Clock “IP Search”, you will find
the device ip, see below picture
Picture 6 IP Configure
4.6 Select the device to configure IP, see below picture
Picture7 IP Configure
4. 7 Default IP setting:
IP address: 192.168.1.10
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.1
User name: admin
Password: no password
4.8 Open IE type IP address. login with user name
and password, see below picture.
Picture 8
WEB GUI After login, enter into below picture
4.9 Login with user name and password, see below picture
Picture 9 Bit rate type
Picture10 WEB GUI after login
Equipment specific relevant parameter Settings please
refer to IP camera user manual in the CD “IPC Fast User
Manual.pdf” and “IP Camera user manual Common
Version.pdf”.
5.SPECIFICATIONS
Model
IV-BUF363MP
Camera
Image Sensor
1/3” 3Megapixel Sony Aptina CMOS
Effective Pixels
2048(H) x 1536(V)
Scanning System
Progressive
Electronic Shutter
Speed
Auto/Manual 1/50~1/10000
Min. Illumination
Color: 0. 1 lux /F1.4, B/W: 0.01 lux /F1.4,0 lux (IR on)
S/N Ratio
>50dB
Camera Features
Max. IR LEDs
Length
60 ft
Day/Night
Auto(ICR) / Color / B/W
Backlight
BLC
White Balance
Auto
Gain Control
Auto/Manual
Noise Reduction
3D
Privacy Masking
Up to 4 areas
Slow Shutter
None / Low / Middle / High
Motion Detection
22 x 18 areas
Lens
Focal Length
3.6mm
Max Aperture
F1.2
Mount Type
Board-in Type
Video
Compression
H.264 High Profile / JPEG Snapshot
Resolution
60Hz Mode: 3M (2048 x 1536) / 1080p (1920 × 1080) /
720P(1280 × 720)
Frame
Rate
Main Stream
3M (1 ~ 15fps) / 1080p / 720p (1~25/30fps)
Sub Stream
D1 / CIF (1 ~ 25/30fps)
Bit Rate
H.264: 50K ~ 8000Kbps
Network
Ethernet
RJ-45 (10/100Base-T)
Protocol
IPv4, HTTP, SSL, TCP/IP, UDP, UPnP, ICMP, IGMP,
SNMP, RTSP, RTP, SMTP, NTP, DHCP, DNS, PPPOE,
DDNS, FTP, IP Filter, QoS, Cloud
ONVIF
ONVIF Ver. 2.0
Max. User Access
5 users
Smart Phones
iPhone, Android
Browsers
IE
General
Power Supply
DC12V, PoE (802.3af)
Power Consumption
<10W
Working
Environment
Temperature:14°F~140°F, Humidity: 10%~90%
Ingress Protection
IP66
Dimensions
2.31” x 2.5” x 5.75”
Weight
Appro 0.8 lbs
The Specifications are subject to change without prior notice.
