ID Card Printer - User Manual
29
4.22
4.23
4.24
5.0
5.1
5.2
5.3
5
5.4
5.5
5.6
While trying to feed a card from the hopper,
and having seen the card reach the front
sensor, it took too long for the front sensor
to unblock.
While moving the card backwards to feed
into the flipper, it took too long for the card
to black the mid sensor
While moving the card from the mid sensor
to the standby posi�on, it took too long for
the mid sensor to unblock.
While moving a dye panel edge from the
dye sensor to the printhead, it took too
look for the tacho wheel to move the
required amount. The film has probably
either run out of snapped.
While advancing to the next dye panel, it
took too long for the next panel panel
boundary to be detected.
It took too many a�empts for the printer to
find a par�cular panel of the dye film
(possibly because the dye sensor needs
calibra�on).
A valid dye film RFID tag was found, but no
physical ribbon could be detected while
trying to take up the film slack.
A valid dye film RFID tag was found, but
there were no shots remaining
A�er prin�ng a card, the printer was
unable to decrement the number of
remaining prints on the dye film RFID tag.
While advancing the dye film, and printer
detected the end-of-film marker.
ERROR TEXT DISPLAYED
ON PRINTER
ERROR DESCRIPTION
SOLUTION BY CATEGORY
Out of film
Check dye film is fi�en and not expired.
Also check the film is not torn.
Summary of Contents for ID Maker Edge
Page 1: ......