ID Card Printer - User Manual
30
5.7
5.8
6.0
6.1
6.2
6.3
6.4
6
6.5
7.0
7
7.1
7.2
8
While moving the dye film, too great a �me
elapsed between tacho sensor counts. The
film has probably either run out or snapped.
While trying to take up the film slack, no
tacho pulses were observed within a
reasonable amount of �me.
The fi�ed dye film had an invalid RFID tag.
Either the tag was not programmed
correctly or there is a problem with the
RFID tag reader.
A dye film ribbon was detected, but a valid
dye film RFID tag could not be found. This
printer is not configured to permit tagless
film.
The fi�ed dye film does not have the right
region code for this printer. Try another
roll of film.
Teh fi�ed dye film does not have the right
dealer code for this printer. Try another
roll of film.
ERROR TEXT DISPLAYED
ON PRINTER
ERROR DESCRIPTION
SOLUTION BY CATEGORY
The fi�ed dye film does not have the right
project code for this printer. Try another
roll of film.
The fi�ed dye film does not have the right
grade code for this printer. Try another
roll of film.
The printer detected film was loaded when
trying to calibrate dye LEDs and dye motor.
The printer detected film was loaded when
trying to carry out a soak test.
The printer detected film was loaded when
trying to carry out the cleaning rou�ne.
8.0
While moving the printhead cam to the
closed posi�on, it took too long to detect
the trailing edge of the cam pulley flag.
Wrong film type
Summary of Contents for ID Maker Edge
Page 1: ......