5.
Common Error and Troubleshooting
Item
Common error
Trouble shooting
1
Cutter cannot start
1.Check whether the circuit breaker tripped.
2.Check whether the fuse is burned out.
3.Check whether the red switch is broken.
4.Check the plug connected to electrical box
interface with a multi meter. Check whether
the circuit of the 220V power
2
Cutter suction force
weakened, failed to fix the
materials well
1.Put one piece of plastic film on the surface of
the materials if they are breathable. 2.Clean
the vacuum entrance filter net if it is blocked.
3.Check whether there`s leakage on the
vacuum plate and pipes.
3
Materials couldn’t cut though
1.Knife height not enough; Increase cutting
knife depth.
2.Change new blades.
3.Check the flatness of the cutting table;
Contact services if needed.
4.Materials cannot totally cut off; Put a piece
of perforated paper on the table surfac
4
Could not cut off patterns at the
corners
Open the dialogue box of Cutter Parameter
Setting, reset the Knife Up Compensation
and Knife Down Compensation
5
Files are sent CutterServer
failed
Use Diagnose function in CutterServer, to
check the DSP version
