Industrial Electronic Engineers, Inc.
SIZE
A
CODE IDENT NO.
05464
S036X2–XXX–XXXXX
Van Nuys, California
SCALE N/A
REV
N
SHEET 19 of 49
04/10/02
3.2.3
Personality Interface (Continued)
9600
1200
19200
INTEL
MOT
LCD
NORM
SFTST
Jumper positions are shown above for LCD mode. Filled positions are settings without Interface Converter.
Baud rate jumper must be moved to 1200 (hatched) position if an Interface Converter is installed.
Figure 3–10
Personality Jumper Positions
3.2.4
Power/Data Connector
The Power/Data connector (J1) contact arrangement is shown in the illustration below. See Table 3–4 for
pin assignments.
2
20
1
19
Pin 8 Removed for Keying
Figure 3–11
J1 Contact Arrangement
The 36X2-134 model has a separate power connector J2 and the pin assignments are:
J2-1
+5VDC
J2-2
NC
J2-3
NC
J2-4
COMMON (GND)
J2-5
NC
J2-6
NC
NOTE
IEE recommends that the user install a keying plug in the mating connector at
the Pin 8 location. This will assure that the mating connector is always
installed correctly and will avoid damage to the display.
IEE supplied accessory connectors are properly keyed.
