１３
ACCURA9/9L INSTRUCTION MANUAL
F u n c t i o n s
Exchange barrels
To exchange barrels, press
CLR RESET Key
.
Dispense-pressure and vacuum-pressure returns to the initial setting figures. Dispensing counter
will be cleared ‘0’. The lapsed time is reset when viscosity-compensation is working.
Dispensing
One shot dispensing is operated with
/OFF
key. Level compensation and vacuum compensation works
while Bot-Level and Top-Level are set ‘ON’ on the
D.SAMP
function setting screen.
Continuous dispensing
Continuous dispensing is operated with
SHIFT+ /OFF key
. Continuous dispensing keeps on working
until the Sc (dispensing counter) reaches the initial setting at setting Sc (shot counter). Press
/OFF key
in order
to stop the continuous dispensing. While not setting the dispensing counter, the continuous
dispensing stops by pressing
/OFF
.
Dispense volume fine-adjustment
The dispense volume may increase or decrease slightly when dispense continuously
with a barrel filling with material. Pressing UP key or DOWN key can solve this problem
by changing the shot period to adjust the dispensing volume. This function can be carried out
while other calibrating functions are working in parallel. The fluctuating volume can be allowed
in the setting time
±２０％
except for the following case.
1)
If the initial setting dispense time is 0.100 sec or more, it is unavailable to change to
0.099 sec or less.
2)
If the initial setting dispense time is less than 0.100 sec., it is unavailable to change the
dispense time short.
3) If the dispense period is over 99.999 sec.
When changing barrels, fine-adjusted dispensing period is reset. If the adjusted dispense period i
sover ±20% or the dispense time is required to adjust soon after changing the barrels, a data
sampling is required by changing the dispense period and pressure.
********************
*
SHOT COUNT
*
*
COUNT UP!!
*
********************
Count Up Screen
Dispensing counter/Count-up
Count-up will appear on the screen and buzzer will ring when Sc
(dispensing counter) reaches the initial setting. Reset with
CLR
RESET key
.
