ACT-408A-N270 User Manual
Page 32
2.9.2 Preconfigured Jumpers
WARNING:
Do not change the settings on the jumpers in described here. Doing so may
disable or damage the system.
The following jumpers are preconfigured for the ACT-408A-N270. Users should not
change these jumpers (
Table 2-2
).
Jumper Name
Label
Type
LVDS voltage selection
J_VLVDS1 3-pin
header
Panel Type and Resolution
J_LCD_TYPE1
10-pin header
Table 2-2: Preconfigured Jumpers
2.9.3 Clear CMOS Jumper
Jumper Label:
J_CMOS1
Jumper Type:
2-pin header
Jumper Settings:
See
Table 2-3
Jumper Location:
See
Figure 2-5
If the ACT-408A-N270 fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close the pins for a few seconds then remove the jumper clip.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
Summary of Contents for ACT-408A-N270
