ACT-408A-N270 User Manual
Page 50
3.1 Introduction
IEI provides a RFID tool (RF320) to configure Mifare cards and EM cards. The following
sections describe how to install the RF320 and how to use RF320 to configure Mifare
cards and EM cards.
NOTE:
Attach the RFID cards close to the RFID reader less than 1 cm so that
the cards can be detected effectively.
3.2 Installation
The RF320 must be installed in the ACT-408A-N270 from the utility CD in the package
before using it to configure the RFID cards. To install the RF320, please follow the steps
below. The following example is based on the Windows
®
XP environment.
Step 1:
Run the
RF-320 setup V1.3.2.exe
file from the utility CD.
Step 2:
The
InstallShield Wizard
is prepared to guide the user through the rest of the
process. Once initialized, the
InstallShield Wizard
welcome screen appears
(
Figure 3-1
).
Summary of Contents for ACT-408A-N270
