ACT-408A-N270 User Manual
Page 56
Bits per second
: 19200
Data bits
: 8
Parity
: None
Stop bits
: 1
Flow control
: None
3.5 RF320 Commands
The RF320 provides five commands, including:
Read Block
: read the block data from the Mifare/EM card
Write Block
: write the block data into the Mifare/EM card
Set Mifare Parameter
Get Mifare Parameter
Set RF320 Mode
The following sections describe how to use these commands.
3.5.1 Read Block
To read the block data from a Mifare card, please follow the steps below.
Step 1:
Select
Read Block
in the command area (
Figure 3-6
).
Step 2:
Configure the data, including block, key, key data and time out (
Figure 3-6
).
Step 3:
Click the
Execute
button to execute the command through the selected serial
port (
Figure 3-6
). The raw data of this command shows in the Raw Data area in
the format listed in
Table 3-2
and
Table 3-3
.
Step 3:
Summary of Contents for ACT-408A-N270
