ACT-408A-N270 User Manual
Page 59
Field
Command
Block
KEY
KEY Data
Time Out
Block Data
End
Digit 2
2
1
12
2
32
1
Data WB
00~63
A/B 000000000000
︴
(Hex)
FFFFFFFFFFFF
00~99
(Second)
32 digits
Hex
CR
(0x0d)
Table 3-4: Write Block Raw Data Format
Status (2 digits)
Block Data
END (2 digits)
OK Null CR,LF
(0x0d,0x0a)
ER
Error Code (3 digits) CR,LF
(0x0d,0x0a)
Table 3-5: Write Block Response Format
3.5.3 Set Mifare Parameter
To set parameter of a Mifare card reader, please follow the steps below.
Step 7:
Select
Set Mifare Parameter
in the command area (
Figure 3-8
).
Step 8:
Select a Mifare mode.
0-UUID: read serial number only.
1-UUID & KEY A: read serial number and use "KEY A" to read "Block' data".
2-UUID & KEY B: read serial number and use "KEY B" to read "Block data".
Step 9:
Configure the block number, and key data (
Figure 3-8
).
Step 10:
Click the
Execute
button to execute the command through the selected serial
port (
Figure 3-8
). The raw data of this command shows in the Raw Data area in
the format listed in
Table 3-6
and
Table 3-7
.
Step 10:
Summary of Contents for ACT-408A-N270
