ACT-408A-N270 User Manual
Page 66
Only handle the edges of the PCB
: When handling the PCB, hold the PCB
by the edges.
4.3 Turn off the Power
WARNING:
Failing to turn off the system before opening it can cause permanent
damage to the system and serious or fatal injury to the user.
Before any maintenance procedures are carried out on the system, make sure the system
is turned off.
4.4 Removing the Rear Panel
To access the ACT-408A-N270 internally, the rear panel must be removed. To remove the
rear panel, please follow the steps below.
Step 1:
Follow all anti-static procedures
. See
Section 4.2
.
Step 2:
Turn off the power
. See
Section 4.3
.
Step 3:
Put the front panel of the ACT-408A-N270 on a table.
Step 4:
Remove the Terminal Block connectors
. Remove the terminal block
connectors (
Figure 4-1
) from the top and bottom panel. A flat headed
screwdriver may be required to remove the connectors.
Step 5:
Remove the rear panel
. Remove the screws (
Figure 4-1
) from the rear panel
and lift the rear panel off the ACT-408A-N270.
Summary of Contents for ACT-408A-N270
