AFL2-17AB-H61
P a g e 26
Anti-static Discharge
: If a user open the rear panel of the flat bezel panel PC,
to configure the jumpers or plug in added peripheral devices, ground
themselves first and wear and anti-static wristband.
4.3
In s ta lla tio n a n d Co n fig u ra tio n S te ps
The following installation steps must be followed.
S te p 1:
Unpack the flat bezel panel PC.
S te p 2:
Install the HDD.
S te p 3:
Install the K-type temperature sensor.
S te p 4:
Install the RFID reader (optional).
S te p 5:
Install the CD-ROM (optional).
S te p 6:
Configure the system.
S te p 7:
Connect peripheral devices to the flat bezel panel PC.
S te p 8:
Mount the flat bezel panel PC.
S te p 0:
4.4
HDD In s ta lla tio n
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To install the HDD into the AFL2-17AB-H61, please follow the steps below:
S te p 1:
Remove two (2) retention screws from the HDD cover (
).
Summary of Contents for AFL2-17AB-H61 Series
