IEI Technology AFL3-W15C-ULT3, User Manual

AFL3-W15C/W19C-ULT3 Panel PC

Page 40 

3.12.3 Cabinet and Rack Installation 

The AFL3-W15C/W19C-ULT3 flat bezel panel PC can be installed into a cabinet or rack. 

The installation procedures are similar to the panel mounting installation. To do this, 

please follow the steps below: 

 NOTE: 

When purchasing the cabinet/rack installation bracket, make sure it is 

compatible with both the AFL3-W15C/W19C-ULT3 flat bezel panel PC 

and the rack/cabinet into which the AFL3-W15C/W19C-ULT3 is 

installed. 

Step 1: 

Slide the rear chassis of the AFL3-W15C/W19C-ULT3 panel PC through the 

rack/cabinet bracket until the frame is flush against the front of the bracket. 

Step 2: 

Insert a M5*50 screw into the screw hole on the side of the rack mounting 

bracket. Then, install the following components onto the screw in sequence.   

See 

Figure 3-26

. 

Sequence Item 

Photo 

Instruction 

1 Spring 

Install a spring onto the screw. 

2 Nut 

Tighten a nut until the spring is 

compressed enough for plastic cap.     

3 Plastic 

cap 

Tighten a plastic cap onto the end of 

screw thread. 

Step 3: 

Repeat 

Step 4

 to install the other three screws into the sides of the two rack 

mounting brackets.