DRPC-124-EHL
Page 13
3.3
Storage Installation
The
DRPC-124-EHL
supports three types of M.2 storage to install an M.2 module, please
follow the steps below.
Step 1:
Locate the M.2 module slot. See Section 4.19
Step 2:
Remove the retention screw secured on the motherboard.
Step 3:
Line up the notch on the module with the notch on the slot. Slide the M.2 module
into the socket at an angle of about 20º (Figure 3-2).
Figure 3-2: Inserting the M.2 Module into the Slot at an Angle
Step 4:
Secure the M.2 module with the previously removed retention screw (Figure 3-3).
Figure 3-3: Securing the M.2 Module
3.4
IO extension Installation (Optional)
DRPC-124-EHL
series products have reserved serial port expansion capabilities, and
provide optional wire. To install, follow the steps below.
Summary of Contents for DRPC-124-EHL Series
