IEI Technology EBC-3000, Quick Installation Manual

 
 
EBC-3000                                IEI Technology Corp.                             Page  7 

Figure 14: Power Supply Bracket Retention Screws 

Step 5: 

Replace the power supply. 

Step 6: 

Secure the power supply bracket to the power 
supply and then secure the power supply bracket to 
the chassis as shown in 

Figure 14

.

Step 7: 

Secure the power supply to the front panel of the 
chassis with the three screws as indicated in 

Figure 

13

. 

Step 8: 

Connect the power supply to the SBC according to 
the SBC user manual. 

SYSTEM FAN REPLACEMENT 

To replace the system fan please follow the steps below. 

 NOTE: 

Please ensure that the power of the computer is switched off before
fan replacement procedure. 

Step 1: 

Remove the chassis cover. 

Step 2: 

Disconnect the system fan cable from the SBC. 

Step 3: 

Remove the system fan from the chassis by 
removing the four retention screws on the back 
panel (

Figure 15

). 

Figure 15: System Fan Retention Screws 

Step 4: 

Install the new system fan with the four previously 
removed retention screws. 

Step 5: 

Reconnect the system fan cable connector.