3
INSTALLATION STEPS
To install the ECA-100 chassis, follow the steps below:
Step 1:
Remove chassis cover.
Step 2:
Install motherboard.
Step 3:
Install power supply unit.
Step 4:
Install system fan.
Step 5:
Install hard disk drive.
Step 6:
Reinstall top cover.
Step 7:
Install wall mount brackets.
The installation steps outlined above are described in detail below. Please refer to the
relevant section.
REMOVE CHASSIS COVER
Step 1: Remove the top cover
. Loosen the two thumbscrews on the top panel, slide
the cover outward, and then lift the cover up gently.
Step 2: Remove the front panel
. Remove nine screws from the front panel, two on
left panel, three on right panel and four on bottom panel.
MOTHERBOARD INSTALLATION
Step 1:
Install the motherboard.
Align the screw holes on the motherboard with
the standoffs on the bottom panel. Secure the motherboard with the screws as figure
shown below.
Summary of Contents for ECA-100
Page 9: ...8 ...