ECN-581A-QM57 Multimedia Box
Page 21
If the ECN-581A-QM57 fails to boot due to improper BIOS settings, the clear CMOS
jumper clears the CMOS data and resets the system BIOS information. To do this, use the
jumper cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to
pins 1 and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in
3
Table 3-4
.
Clear CMOS
Description
Short 1 - 2
Keep CMOS Setup
Default
Short 2 - 3
Clear CMOS Setup
Table 3-4: Clear CMOS Jumper Settings
The location of the clear CMOS jumper is shown in
3
Figure 3-10
below.
Figure 3-10: Clear CMOS Jumper
3.4.4 ME RTC Register Jumper
Jumper Label:
ME_RTC1
Jumper Type:
3-pin header
Jumper Settings:
See
Table 3-5
Jumper Location:
See
Figure 3-11
Summary of Contents for ECN-581A-QM57
