GRAND-C422-20D
Page 28
4.2 Memory Module Replacement
To replace memory modules, follow the steps below:
Step 1:
Turn off the GRAND-C422-20D. Disconnect the power adaptor, network cable(s),
and any other connectors or cables from the GRAND-C422-20D.
Step 2:
Put on an antistatic wrist strap to prevent electrostatic discharge. The crocodile
clip should be connected to the ground.
Step 3:
Loosen the two captive screws on the rear of the GRAND-C422-20D. Slide the
top cover towards rear panel. Grab the handle to lift the top cover off the system.
Step 4:
Locate the memory module on the main board. Release the memory module by
pulling the ejector clips gently out of the sides of the RAM slot.
Summary of Contents for GRAND-C422-20D
