GRAND-GL Series
Page 17
3.4 Memory Module Installation
The GRAND-GL has two memory slots that support DDR4 SO-DIMMs. To install a
memory module, follow the steps below:
CAUTION:
For dual channel configurations, always install two identical memory
modules that feature the same capacity, timings, voltage, number of
ranks and the same brand.
Step 1:
Remove the case cover. See
Section 3.3
above.
Step 2:
Grip a RAM on the edges to avoid touching contacts or circuitry on the module.
Step 3:
Align the notch with the ridge in the slot. Insert the module into the slot. Verify
that the metal connectors are completely inserted into the slot.
Step 4:
Carefully press down on the module until the retention clips lock the module into
place.
Step 5:
Close the case cover and fasten the screws. Connect the power adaptor and
cables back to the GRAND-GL.
Summary of Contents for GRAND-GL Series
