IBX-660 Industrial Edge Storage Server
Page 21
Figure 3-8: Mounting Bracket Installation
Step 4:
Drill holes in the intended installation surface.
Step 5:
Align the mounting holes in the sides of the mounting brackets with the predrilled
holes in the mounting surface.
Step 6:
Insert four retention screws, two in each bracket, to secure the system to the
wall.
Step 0:
3.7 Power-On Procedure
3.7.1 Installation Checklist
WARNING:
Make sure a power supply with the correct input voltage is being fed into
the system. Incorrect voltages applied to the system may cause damage to
the internal electronic components and may also cause injury to the user.
To power on the IBX-660, please make sure of the following:
The HDD/SSD is installed
The LAN cable is connected
The power cables are plugged in
Summary of Contents for IBX-660 series
