IBX-660 Industrial Edge Storage Server
Page 41
WARNING:
The following instructions should only be performed by an authorized
and trained technician.
Before starting, please ensure that you turn off the IBX-660, disconnect
the power adaptor, network cable(s), and also remove any other
device/cable that is attached to the server.
Take Anti-Static precautions whenever maintenance is being carried
out on the system components. Failure to take anti-static precautions
can cause permanent system damage. For more details on anti-static
precautions, please refer to
Section 3.1
5.1 Component Replacement Procedure
WARNING!
Users are not advised to attempt to repair or replace any internal or
external components of the IBX-660 industrial edge storage server
other than those listed below. If any other components fail or need
replacement, contact the IEI reseller or vendor you purchased the
IBX-660 from or contact an IEI sales representative directly. To contact
an IEI sales representative, please send an email
The industrial server components listed below can all be replaced if they fail:
SO-DIMM module (see
Section 3.4
Hard disk drive (see
Section 3.5
Summary of Contents for IBX-660 series
