IBX-660 Industrial Edge Storage Server
Page 10
2.1 Unpacking
To unpack the IBX-660, follow the steps below:
Step 1:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
external (second) box.
Step 2:
Open the external (second) box.
Step 3:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
internal (first) box.
Step 4:
Lift the system out of the boxes.
Step 5:
Remove both polystyrene ends, one from each side.
Step 6:
Make sure all the components listed in the packing list are present.
2.2 Packing List
NOTE:
If any of the components listed in the checklist below are missing, do
not proceed with the installation. Contact the IEI reseller or vendor the
IBX-660 was purchased from or contact an IEI sales representative
directly by sending an email to
The IBX-660 is shipped with the following components:
Quantity
Item
Image
1
IBX-660 industrial edge storage
server
Summary of Contents for IBX-660 series
