IBX-660 Industrial Edge Storage Server
Page 20
WARNING:
Users are strongly recommended to turn OFF the IBX-660 before replacing the
hard drive to reduce the risk of electric shock.
CAUTION:
IEI disclaims any responsibility for product damage/malfunction or data
loss/recovery due to misuse or improper installation of hard disks in any
occasions for any reasons.
3.6 Mounting the System
Mounting instructions of the IBX-660 are given in the following sections. The mounting kit
described below can be separately purchased. Please contact IEI sales representative
directly for detail information. The mounting instructions are described below.
3.6.1 Mounting with Optional Wall Mount Kit
To mount the IBX-660 onto a wall or some other surface using the optional wall mount kit,
please follow the steps below.
Step 1:
Turn the IBX-660 over.
Step 2:
Align the two retention screw holes in each bracket with the corresponding
retention screw holes on the bottom surface.
Step 3:
Secure the brackets to the system by inserting two retention screws into each
bracket (
).
Summary of Contents for IBX-660 series
