IBX-660 Industrial Edge Storage Server
Page 27
4.1 Introduction
The BIOS is programmed onto the BIOS chip. The BIOS setup program allows changes to
certain system settings. This chapter outlines the options that can be changed.
NOTE:
Some of the BIOS options may vary throughout the life cycle of the
product and are subject to change without prior notice.
4.1.1 Starting Setup
The UEFI BIOS is activated when the computer is turned on. The setup program can be
activated in one of two ways.
1. Press the
D
ELETE
key as soon as the system is turned on or
2. Press the
D
ELETE
key when the “
Press Delete to enter SETUP
” message
appears on the screen.
0.
If the message disappears before the
D
ELETE
key is pressed, restart the computer and try
again.
4.1.2 Using Setup
Use the arrow keys to highlight items, press
E
NTER
to select, use the PageUp and
PageDown keys to change entries, press
F1
for help and press
E
SC
to quit. Navigation
keys are shown in.
Key
Function
Up arrow
Move to the item above
Down arrow
Move to the item below
Left arrow
Move to the item on the left hand side
Right arrow
Move to the item on the right hand side
+
Increase the numeric value or make changes
Summary of Contents for IBX-660 series
