IOVU-07F-AD RISC-based Panel PC
Page 11
To unpack the panel PC, follow the steps below:
WARNING!
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the system has been
properly installed. This ensures the screen is protected during the
installation process.
Step 1:
Carefully cut the tape sealing the box. Only cut deep enough to break the tape.
Step 2:
Open the box.
Step 3:
Lift the IOVU-07F-AD out of the box.
Step 4:
Remove both polystyrene ends, one from each side.
Step 5:
Pull the plastic cover off the IOVU-07F-AD.
Step 6:
Make sure all the components listed in the packing list are present.
Step 0:
2.1 Packing List
NOTE:
If any of the components listed in the checklist below are missing, do
not proceed with the installation. Contact the IEI reseller or vendor the
IOVU-07F-AD was purchased from or contact an IEI sales
representative directly by sending an email to
31
The IOVU-07F-AD is shipped with the following components:
Summary of Contents for IOVU-07F-AD
