IOVU-07F-AD RISC-based Panel PC
Page 18
3.4 Mounting the System
WARNING!
When mounting the panel PC, it is better to have more than one person
to help with the installation to make sure the panel PC does not fall
down and get damaged.
Four methods of mounting the IOVU-07F-AD are listed below.
Wall
mounting
Panel
mounting
Arm
mounting
Stand
mounting
The four mounting methods are described below.
3.4.1 Wall Mounting
To mount the IOVU-07F-AD onto the wall, please follow the steps below.
Step 1:
Select the location on the wall for the wall-mounting bracket.
Step 2:
Carefully mark the locations of the four screw holes in the bracket on the wall.
Step 3:
Drill four pilot holes at the marked locations on the wall for the bracket retention
screws.
Step 4:
Align the wall-mounting bracket screw holes with the pilot holes.
Step 5:
Secure the mounting-bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them (
).
Summary of Contents for IOVU-07F-AD
