IOVU-07F-AD RISC-based Panel PC
Page 21
Figure 3-6: Secure the IOVU-07F-AD
3.4.2 Panel Mounting
The IOVU-07F-AD can be mounted in a panel.
CAUTION:
When mounting the IOVU-07F-AD, take care to tighten the retention
screws or bolts until fully secure, but do not over tighten. Over
tightening the retention screws or bolts may cause them to become
stripped, rendering them useless.
To mount the IOVU-07F-AD into a panel, please follow the steps below.
Step 1:
Select the position on the panel to mount the IOVU-07F-AD.
Step 2:
Cut out a section from the panel that corresponds to the rear panel dimensions
of the IOVU-07F-AD. Take care that the panel section that is cut out is smaller
Summary of Contents for IOVU-07F-AD
