IOVU-07F-AD RISC-based Panel PC
Page 30
The IOVU-07F-AD provides a demo app to select the RS-232, RS-422, or RS-485 mode
for the COM 2 port. Please refer to
Section 4.8
for details.
3.5.4.3 Connecting the Serial Port
Follow the steps below to connect a serial device to the IOVU-07F-AD.
Step 1:
Insert the serial connector
.
Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See
.
Figure 3-17: Serial Device Connector
Step 2:
Secure the connector
. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Step 0:
Summary of Contents for IOVU-07F-AD
