iSignager-300/300WL
Page 30
A.2 Checking Connection
There are several ways to check if the connection exists between the iSignager-300 and
PC.
A.2.1 Check the LED
Check the LEDs on the top of the LAN port in the bottom panel of the iSignager-300. The
green LED on the right side indicates LAN or Wifi is linked on the port. The orange LED on
the left side indicates transmission activity.
A.2.2 Ping in DOS Environment or Hyper Terminal Session
A.2.2.1 PC
To check if the specific IP connection exists in the server side, check in DOS environment
of the server. In DOS environment, type “ping” followed by the LAN IP or WLAN IP, e,g.
ping 10.10.12.82. Press Enter. If the reply message is shown, the connection exists, e.g.
Reply from 10.10.12.82: bytes=32 time<10ms TTL=128
Reply from 10.10.12.82: bytes=32 time<10ms TTL=128
Reply from 10.10.12.82: bytes=32 time<10ms TTL=128
A.2.2.2 iSignager-300
To check if the specific IP connection exists in the client side, check in a Hyper Terminal
session of the iSignager-300. To create a Hyper Terminal session, please refer to
Section
. In Hyper Terminal session, type “ping” followed by the LAN IP or WLAN IP, e,g. ping
10.10.19.253. Press Enter. If the reply message is shown, the connection exists, e.g.
64 bytes from 10.10.19.253: icmp_seq=0 ttl=64 time=1.3 ms
64 bytes from 10.10.19.253: icmp_seq=1 ttl=64 time=0.7 ms
64 bytes from 10.10.19.253: icmp_seq=2 ttl=64 time=0.5 ms
Summary of Contents for Isignager-300
