ITDB-100L Barcode Reader
Page 22
3.3.2 Ethernet Connector
The ITDB-100L is equipped with an Ethernet connector that allows connection to a
computer/network hub. Follow the steps below to connect the ITDB-100L to a
computer/network hub by using the supplied Ethernet cable.
Step 1:
Locate the Ethernet connector
. The location of the Ethernet connector is
shown in
Step 2:
Align the connectors
. Align the Ethernet connector on the LAN cable with the
Ethernet connector on the ITDB-100L. See
Figure 3-8: Ethernet Connection
Step 3:
Insert the LAN cable Ethernet connector
. Once aligned, gently insert the LAN
cable Ethernet connector into the Ethernet connector on the ITDB-100L.
Step 4:
Connect the other end of the Ethernet cable to the Ethernet connector of a
computer/network hub.
Summary of Contents for ITDB-100L
